Program a card
Writes the spirit firmware onto the blank card in your Workshop Computer, straight from this page. You need an access code, a USB-C cable, and Chrome or Edge on a computer.
This browser cannot talk to USB devices. Open this page in Chrome or Edge on a desktop or laptop.
1
Enter your access code
It came with your card or from the event you attended.
2
Put the Computer in bootloader mode
- Insert the card you want to program and plug the USB-C cable into the front of the Computer.
- Hold the small boot button tucked below the main knob.
- Tap RESET, next to the card slot, then let go of both.
- Press Connect and pick RP2 Boot from the list.
3
Program
Takes about a minute. Leave the cable alone until it finishes. Whatever was on the card is replaced.